Making the ARRL 3W CW Transmitter

Discuss and share ideas for making your own amateur radio gear.

Moderators: W5ALT, AC2C

Making the ARRL 3W CW Transmitter

Postby VA7LAS » Tue Dec 13, 2011 4:27 pm

I'm going to try the Famous 3W CW Transmitter, apparently originally shown in ARRL magazine (http://www.qsl.net/kc6wdk/QRP/transmitter2.htm I have a couple questions:

First, how do you get 3W out of 12V? Assuming around Class C, that would give you a max RMS voltage of around 7-8 volts, which into a 50 Ohm load would be about a watt.

Second: is the text on how to wind L1 correct? It looks like the tap should be on the end connected to the collector, NOT to C1. Then L1/L2 and L3/L4 would be almost identical. (I assume the "cold end" is the lower end as shown in the diagram)

Oh, and one more: can I put in a reactance (capacitor?) in series with the crystal and "bend" the resonance frequency a bit? I have a 7050 MHz crystal and would love to get to 7055...

Lloyd
VA7LAS
"Apart from that, Mrs Lincoln, how did you like the play?"
VA7LAS
Member
 
Posts: 6
Joined: Sat Nov 26, 2011 8:53 pm
Location: Delta, BC CANADA

Postby k8jd » Mon Dec 26, 2011 6:47 pm

That tap on the coil is to match the low Z output from the collector to the high Z of the tuned circuit. I have a MFJ QRP rig or two that put out 3 and 5 watts with 12 V supply !
73 from K8JD, SKCC 1395, Centurion 18, Tribune 12, Band Endorsements; 160, 80, 60, 40, 30M, 20, 17, and 10M

Ham radio is real Radio, CW is real Hamming!
k8jd
Member
 
Posts: 380
Joined: Fri Feb 24, 2006 5:15 pm
Location: Commerce, MI


Return to HomeBrew

Who is online

Users browsing this forum: No registered users and 1 guest

cron